Vinyl Board Stickers

- Make sure the surface is completely clean and dry before applying. If there is any residue the sticker will be quite difficult to apply so make sure you give the surface a really good clean and dry
- If required lay something heavy on your sticker for a short while before applying so that it is nice and flat before you begin
- Wipe the surface with methylated spirits and some water to remove any extra dust or grime
- Without removing any of the backing paper or top application tape make sure you know where you would like to position your sticker
- When you are ready carefully peel the backing paper off lay the sticker in its desired position and use a hard card such as an eftpos/credit card to slowly push down the sticker working from the middle to the sides
- If you do get any bubbles that show up you can try to gently move these out with the card or use a little pin in the centre of the bubble
- Slowly peel the top applicator tape away starting at the corner, stay as close to the sticker and the surface while doing this and DO NOT lift the application tape upwards.
- If you do get any lift happening use the card to press down again over the application tape and try peeling it off again
- All done ! Enjoy your epic new sticker!